7-Day Electromechanical Controller

  • Easy-to-set controllers are ready to use out of box, program in less than a minute
  • Fast, easy index pin memory permits programming unit to exact time requirements
  • Repeats cycle daily or weekly; has manual override


Timing Capacity/Range 7-day (2-hour increment)
Horsepower 1/3 HP
Power Capacity 125 VAC, 15 amps, 1875 watts
Features turns equipment on/off, manual override
Dimensions 3-1/4″x2-3/4″x2″
Weight 5 ounces
A/C Plug (Y/N) Y(Included)

Available on backorder


Automatic mechanical units turn on and off any piece of equipment. Use them to turn on chemical, water, and air pumps as part of a sampling process. Automate testing, heating, mixing, or even feeding of animals. Easy-to-set controllers are ready to use out of the box, program in less than a minute, and plug into a wall outlet. They have all of the flexibility and simplicity desired for a lab’s routine needs.


Pins constantly display all of the time settings. UL listing allows use with electrical equipment to 125 VAC, 15 amps, 1875 watts, and 1/3 horsepower. A single glance verifies an entire program. If a change is necessary, it takes only a second to raise or lower a pin.


Twenty-four-hour unit may be set in any number of 15-minute increments, 7-Day Controller in any number of 2-hour increments. The 7-day unit may be programmed to skip weekends or any days. Using the manual override, equipment can be switched on/off immediately without unplugging and without disturbing the program. Rated to 15 amps. Size is 3-1/4 x 2-3/4 x 2 inches. Weight is 5 ounces.

Additional information

Weight 0.35 lbs

There are no reviews yet.

Be the first to review “7-Day Electromechanical Controller”

Privacy Preference Center